WLJH T5 17 37 74 2721 Pink Dashboard Gauge Instrument Cluster Panel Dash Led Light Lamp With Twist Lock Socket,Pack of 6

Holy moly these are bright
I purchased the white bulbs, because after being spoiled with LED’s in the instrument cluster, I had to do the rest of the interior lighting.For my application, these bulbs were used to replace the burned (and unknown-to-me-existence) glove box light & automatic shifter console lighting in my 2003 Tacoma… obviously an autotragic.The factory bulb lights up well enough, has an orange condom, and really looks lack luster. Maybe in the early 2000’s it was the latest and greatest, but let’s face it we’ve all been blown away by the dashboards of late model vehicles, and their fancy colors – and crisp white LED backlighting. I know I was, am, and will be. With nice LED backlit instrumentation, looking over at the shifter console with it’s soft warm white glow – like grandma’s clear Christmas lights from 1967 – was really unappealing. The hunt for a #74 LED began.First and foremost, while I am sure there are other LED’s that will work here just fine, the problem with these T5 LED’s on the market is 90% of them have a single LED firing straight out. These have 3 LED’s, each of which are probably brighter than most of the T5 LED’s currently on Amazon. That was a really big plus, because the LED’s (T10/#194) that I installed in the dash board are so bright, I have to keep the dimmer down around 25-35% so they don’t glare so bad at night. Well when you do that, all the incandescent bulbs are so dim you can barely see them. Now the shift console matches the brightness of the instrument cluster – a nice and welcome perk.Now the hunt is on to find suitable T4 neo-wedge bulbs for the climate controls, and of course the venerable white 4-Runner plate that doesn’t have an orange filter. Hopefully, equally bright LED’s in that size are out there?Keep in mind, these are much brighter at their given voltage than incandescent bulbs. If you’re OCD and picky about uneven lighting, you’re going to want to replace all bulbs with like-brightness or you’ll run into this issue like I am.If these bulbs stand the test of time and durability and don’t burn out in a few months, they will be my go-to #74 bulb and I’ll buy spares to keep on hand in the event that these disappear off the market for whatever reason. Hurricane. Tsunami. Godzilla. You get the point.

2004 Ford Ranger insturment cluster
I ordered two packs of these LED lights for my 2004 Ford Ranger. The tachometer wasn’t lighting up on the right side half of it anymore. I am not 100 percent sure, but I think Ford switch to this gauge cluster in 2003. Prior to that, the gauge cluster was completely different, and had the old school analogue odometer that rolled over for each mile. This one has the digital odometer, as you can see in my photo. I ordered two packs of the LED’s, because this crazy gauge cluster uses 11 (yes ELEVEN) tiny bulbs to light everything up. These LED’s came with sockets, but they DO NOT FIT in my gauge cluster. I had to use a push pin, and remove the old Ford factory bulbs, and insert these new LED’s into the existing sockets. Was a pain, from start to finish. Polarity does matter. I had to rotate the LED bulbs until I got everything in the dash to light up properly. So far, they are super bright. The only indicator light that doesn’t come on is my cruise control one. I didn’t notice that until days later, and I don’t feel like tearing the dash out again (major pain!) to try and figure that out. The LED’s are very bright, like I said earlier. I do think the light doesn’t quite illuminate the temperature and gas gauges as well as it should. Anyway, I hope this review is helpful to other Ford owners who have this era of the Ford Ranger. I believe the Ford Explorer and Explorer Sport Trac also used the same if not similar gauge cluster back then. The old school analogue gauge cluster before the one in my truck, used six large type 194 bulbs to illuminate, plus smaller smaller bulbs for each individual indicator light (i.e. check engine light, etc.).

Worst product ever! Dont buy!
Absolute trash! I bought 1 pack and didnt realize 3 out of the 6 bulbs didnt work before I bought a second pack. The second pack 1 out of 6 worked. Flipped them around and still trash. Tried different sockets….still trash. Just wasted $16 out of the 12 bulbs I bought only 4 worked. The ones that worked look good but only 1/3rd of my cluster is lit with led. Will never order again. Trash! I gave 5 stars for brightness cause the ones that work are bright. But as far as easy to install. No because you have to do a bunch of crap just to make sure they are going to light up. Such a tight squeeze. Not worth it. This was supposed to be pull cluster…replace all lights…reinstall cluster. They should send me 5 free packs so I can finish the job! The picture shown the leds are on the left gauges and the stock bulbs are on the right. In the picture the stock lights look better but the led bulbs that actually worked are alot brighter. Just finished with customer care and got a full refund. I suggest buying somewhere else.

Solo sirven 3 leds de 6 una una total perdida

used these to put led lights in a set of autometer gauges, worked great!

La luz es más suave que la de las fotos y se ve mejor, no deslumbra y la luz relaja.Perfecto y ha llegado antes de tiempo.