Flying Banner Car Seat Covers Front Seats and Rear Bench Mesh Fabric Rear Bench Split Polyester Cover Easy Installation SUV CAR Woman Lady Femal (Front Set, Black Red)

Just the right choice
The fit is excellent and comfortable to slide in on to drive. There’s been no further rips and the look is great!

60/40 tips // No holes for center headrest!
Front seats are pretty straightforward (though tips below). If you’re not sure, start in the back! (My pictures are the mint blue color).As other reviews have said, these are not sturdy, so I do not recommend with kids or dogs or anything else that requires regular washing. They are pretty, though! (This shade of blue is one of my favorite colors so maybe I’m a bit biased!)The initial install took ages (an hour just for the back seat!), but now I know how to fit them, I’m sure it will be much faster after washing!I have a small hatchback (Ioniq). It took a while for me to realize these covers fit much better if you remove one of the middle panels (my car has 60/40 split, so it’s perfect) – also remove the panel from the seat for a better fit. But this does require a small cut in the cover. It may be in the instructions, but the pictures are so small it’s not clear. It shows unzipping to fold down one side, but that isn’t possible as is because there is cloth connecting the pieces at the top of the zipper (it is just a tiny bit and I suppose if you don’t have a split, and a wide car, it is helpful for a better fit).Also by removing a panel, there are loops in the remaining middle sections that are much better for securing the cover to each seat back.As said in other reviews, not all cars have a back seat that folds up. Mine is the same. Luckily I could barely get my hand under the seat to pull a loop through for attachment to another one. I had some issues with the loops being too big – but tying a knot in the middle of the loops for the hook to go on easily solved this problem.The biggest issue are the holes in the top for the back seat. There are holes for both side headrests, and also seatbelts (side). But nothing for the middle. Luckily my center seatbelt will fit through one headrest hole. But there are no holes for center headrest even though it’s pictured! I’ll take a pair of scissors to make a small cut, maybe some duct tape underneath for stability (I don’t sew). It’ll work for a while, but not sure how it will hold up in the wash.Additionally, for cars with a split, you have to be careful when putting the seat back in place so the cover doesn’t get caught in the latch and ruin.Issue with seat belt buckles – if your car has long straps on the buckles, they’ll be fine, but mine are very short, so it is difficult to fit around. Especially my middle buckle has a gap (nest) it fits in when not in use – there isn’t enough material to allow this well.Front seats – be aware of where the switches/levers are to adjust the seat. Mine are on the seat itself. Luckily I could squish the cover in between, which will help it stay in place! The other issue with front seats is if there is a pocket on the back – the cover covers the pocket so it can’t be used. It looks like the loops to secure the seats go front-to-back. I don’t have the patience for this at the moment (and a bad shoulder). I made a feeble attempt, and I can definitely get the loops under the seat, maybe with some help it would be easier. As I don’t have small kids, I’m not too worried.Caution- the instructions that the seam for the airbag is weak is correct! The covers fit snugly, so be careful where you put pressure, I accidentally broke a few stitches. Easy enough to fix if I need to since it’s only a few weak stitches, but for now it’s not noticeable.Overall, I will keep these because for the cost they’re ok. Other reviews aren’t positive about washing, so I will take extra care and use delicates (maybe hand wash, as the backing is foam!) and air dry when needed. I drive rideshare and am tired of tiny spots on my tan seats that I can’t afford to detail. These at least fit better than random blankets (and are prettier, and no less annoying to fit!).Also note that the headrest covers aren’t stretchy. If you have smaller headrests (like mine are), they will fit loosely – but do have ties so they won’t come off.Sorry photos aren’t in order!

Love the way they look
Kind of hard to put on but I absolutely love the colors and they are really good quality

Invest in better!
I was so disappointed with this purchase. I was excited to get my seat covers, however the quality is VERY low! They ripped as soon as I slipped them on my 2018 Jeep Renegade. Save your money and invest in higher quality seat covers.

Pas du tout adapter et très mauvaise qualité

Covers fit perfectly on my now yassified 2013 Nissan Qashqai J10. The front ones are a bit tight, but they’ll probably settle over time and I’d rather that than loads of wrinkles in the fabric

Cette ensemble s’enfile facilement. Il reste à voir dans la durée.